C H & E Pumps Page - Cross Pump & Equipment (304) 925-2116

CH&E Self-Priming Centrifugal Pumps

Self-Priming Centrifugal Pumps

ABOVE: This self-primer is available in 1-1/2", 2" and 3" sizes and comes in low-to-medium head versions and a 2" enclosed impeller high head system. The higher volume units can achieve a flow up to 360 GPM.

SELF-PRIMING TO 25'
REPLACEABLE VOLUTES
SINGLE & DOUBLE SEALS
BROAD SIZE RANGE

Time-tested as very tough units, CH&E self-priming centrifugals are built to last in rugged dewatering applications. Available in a range of power and sizes from 1" to 6", we fit many applications where self-priming is needed. Mostly low and medium head models, but some higher head versions are available. Call us with your application.

Made in the U.S.A.

The 4800 and 4900 series are available in 3", 4" and 6" sizes, with a maximum output up to 1420 GPM and heads up to 108 feet. All have double shaft seals, replaceable volutes, and removable front covers for clean out or repair without disturbing piping.

	These very versatile units have broad applications where a small self-primer is needed. They are widely used as the primary pumps in portable military systems and as feeder pumps in industrial separators. Available in 1", 1-1/2", and 2" sizes.
	Close-coupled to JM motors, these units can fill the bill when space restrictions, or application preferences exist. Available in 2" and 3" sizes and a 2" higher head version. Maximum volume up to 360 GPM.
	The 4800 and 4900 series are available in 3", 4" and 6" sizes, with a maximum output up to 1420 GPM and heads up to 108 feet. All have double shaft seals, replaceable volutes, and removable front covers for clean out or repair without disturbing piping.

SUPER-SUB SUBMERSIBLE PUMPS

FULL LINE FROM 2" TO 6"; 3-4 HP TO 5" HP
HIGH VOLUME OR HIGH HEAD MODELS
SLIM PROFILES FIT INTO TIGHT SPACE
SILICON CARBIDE SHAFT SEALS EXTEND LIFE

A special family of submersible dewatering pumps built to last under rigorous use conditions. And they are designed to fit where others won't. Bodies are hard anodized aluminum to resist corrosion; the shaft and all fasteners are stainless steel, and the shaft seals are oil lubricated. Controllers are available in NEMA 3R or NEMA 4 versions and explosion proof models are available in 2" and 3" sizes. All units perform to CPB standards and are CSA approved.